Passive:First Steps

Aus Wufiwiki
Zur Navigation springenZur Suche springen

Example Case
This example will give you an easy step by step guide, on how to input a new case in WUFI®Passive. It will be a very easy case and is inspired by the introduction movie. For more advanced stuff, go to the advanced example.

Step Zero: Case 1

In contrast to WUFI®Plus, this section does not contain any essential data but you can name your project and add some remarks.

Figure 1: Case 1

Step One: Climate and Localization

Figure 2: Climate

WUFI Passive's standart climate is the german reference climate as in DIN 4108-6 but we will use a different climate, in our case it will be from Hannover. To input a new climate dataset select the "user defined" scope and press the browse button. After you input some valid data, the climate tab will show some graphs about temperature and radiation. Remember that WUFI®Passive needs a special format of climate files which you can see it in the previous link or in this movie.
If you dont have any climate files formated this way, you can switch to WUFI®Plus and input the climate file there. Detailed instructions can be found here.

Step Two: Building geometry

There are 3 ways to define a building in WUFI®Passive, the easiest one being the building wizard for very simple buildings or spaces. The two other ways are verticles and Sketchup, which work way better if you want to build a more complex building.
For our example we will use a simple room with an unheated attic and a slab on grade zone.

Building wizard and orientation

We will add 4 windows on the south side using the visualization box in the bottom left corner. Click the orange boxed "Windows/openings" button and a new page will appear. Here click the green boxed button "Edit List" and insert the windows as seen in the picture.

How to input windows

Be aware that the coordinate system of the chosen wall starts in the bottom left and the X’ – axis is the orientation of the window in horizontal direction and the Y’ – axis in vertical direction.
There is also a movie about this topic.
The door in the north orientet wall can be implemented almost the same way. Turn the building in the visualization box, create a "window" just like before and afterwards right click the new element and change its properties to opaque.

Implementation of the exterior door

To clarify this is an exterior door, click on "Component 5" in the tree (if you are looking at the door in the visualization box, it will be red edged) and make a check on the "exterior door" option.

Step Three: Options for the passive house

Next click on the "PH case:" section on the tree. Per default its value is "residential" and we will not change something in the "general" tab here. Instead we will go to "Additional data" and input the values being boxed blue in the picture.

Only two values are needed here

Other than that we will not change any standart values but instead are going to the next section: "Foundation interface". There we will also just add some additional values.

Again only two values

Step Four: Zonal data

In this section we will define the tfa and the gross volume of our building. In the green box we define the properties of our wall, in this case our wall is massive.

Zonal values


Step Five: Defining the components

Naming the visualized components

The next subsection is all about the components and their assemblies. First we click on "Visualized components" and name each component.
Then we define the assemblies of all components and we will start with the exterior wall as described in this movie.