Plus 2.X:Input

This case will help you immerse yourself deeper into WUFI plus. After having performed and understood it you will be a WUFI expert! Like the first (easier) case, this case is mostly built up following the navigation tree.

This case is about modelling a house (like we did before in example 1st) with an building attachment (used as fitness studio). As it is pretty complicated and complex small movie sections come along each chapter.

It begins quite similar to our first example, so the first chapters are very much the same.

STEP one: Information and setting of Framework Conditions

Proceed like explained in STEP one in the first case.

STEP two : Definition of the climatic Conditions

Again we want to use the predefined climate of Holzkirchen, and also to create an adequate soil climate. Read STEP two of the first case on further information on how to proceed.

STEP three: Generating of Building Geometry

Like we did before we want to use the Building Wizard to create our building. But additionally a building extension (for a fitness studio) is to be added to the house using vertices.

With the Building Wizard

Again we assume a simple case with one heated slab-on-ground zone and an inclined unheated attic. Just enter the same inputs as in Figure 5 for you building in the Building Wizard.

Figure 5: The Building Wizard

Using vertices

The simple building created with the [[Plus 2.X:Building#Building Wizard|Building Wizard] shall be expanded. The building extension will serve as fitness studio. The readily expanded building should look like the one shown in Figure 6.

Figure 6: The expanded building

Creating it you need to work with vertices. For more information on this topic, click here.
By copying and moving preexisting vertices and components and by creating new vertices and components, any desired building geometry can be generated. Of course there are several possible procedures to create the desired building extension.

One way to proceed is shown in the first movie.

Te other movie gives an overview on working using the 3D Edit.

STEP four: Windows

The building must be staked out with windows as well. The following pictures show you how windows should be placed along the walls. Measurements are

WINDOW	length [m]	height[m]
a	1,2	2,1
b	0,9	1
c	3	1

Figure 7: The windows 1

Figure 8: The windows 2

Try to get the windows right yourself. If you need help doing it, consult the chapter on windows. The following film shows you how to place the windows in the right way.

Step 5: Creation of the zones

zuweisen, blabla, farben