1D:Dialog MeasuredData

Dialog: Measured Data

This dialog serves to specify ASCII files with measured courses or profiles which you want to display in the result graphs, together with the calculation results. This allows a direct comparison of calculation and measurement.

Clicking on the button "..." will open a file dialog for selecting the file with the measured data. Then click on the button "Import" to add the data to the calculation results in memory. WUFI expects the file extension *.MES.

In order to add imported curves to a diagram, right-click in the 1D:Dialog_ResultGraphs | curves list]] of the respective diagram to open the subdialog Insert Curves and select the desired curve among those offered in the list. The imported data are included in all lists since they have no specified curve type.
 

The files for the measured courses are text files with one column for the time axis (in hours) and one or several columns for the measured data (in the units used by WUFI for this curve type).

The files for the measured profiles are text files with one column for the x coordinate (in cm) and one or several columns for the measured data (in the units used by WUFI for this curve type).

Example: water contents of drying lime silica brick masonry were measured at six points in time, spread over four years. Compare the measurements, taken at two locations each time, with the results of a calculation:

Drying.mes:

	2074		80		97
	2502		78		93
	10027		45		49
	18914		21		26
	27504		18		27
	32056		21		28