Plus2:Status and Results

Aus Wufiwiki
Zur Navigation springenZur Suche springen

The Status and Results Box

Error Messages

P2-sr-error.png

As long as there is still input data missing the status and results box shows error messages. Double clicking on it makes Wufi®plus jump to the cause of the error. The error messages are constructed according to the structure of the Navigation Tree, so navigating to the cause is just a matter of tracing the error message line by line in the Navigation Tree.

Starting the calculation

P2-sr-start.png

After all essential data has been inputted, the calculation can be started in the Status and Results Box clicking the "Start" button.

P2-sr-calculation.png

During the calculation the simulated temperature humidity distribution can be observed in realtime for every component. However the calculation can be accelerated by deactivating this option. Just click on the "Maximum Speed" button. If the "Retain Calculation Results" box was check-marked theses films (and graphics as well) are retained for the respective component.

The Scope/Sequence button P2-scseq.png allows you to decide which information is showed in the Status and Results Box. Click the button to make the the Scope/Sequence window open up. Move the elements to the desired side using drag and drop (left side: chosen, right side: not chosen).

After the calculation

P2-sr-results.png

After the calculation a first brief summary containing some basic information (see picture above) can be found in the Status and Results Box.


For more information on the results of a calculation, click here.