Len: Die Seite wurde neu angelegt: = Summary: Preparing a Calculation =
This is an overview of the steps that have to be taken before you can start a calculation.
* You may enter some opt...

2008-08-13T06:57:15Z

Die Seite wurde neu angelegt: = Summary: Preparing a Calculation = This is an overview of the steps that have to be taken before you can start a calculation. * You may enter some opt...

Neue Seite

= Summary: Preparing a Calculation =
 

This is an overview of the steps that have to be taken before you can start a calculation.

* You may enter some optional information about the [[1D:Dialog_Project | project]] and the [[1D:Dialog_Case | case]]. 
  
* You must define the [[1D:Dialog_Assembly | assembly]] of the component (i.e. its layer sequence and the layer thicknesses) and you must enter the [[1D:Dialog_MaterialData | material data]] for the individual layers. The material data may be entered by hand or taken from the [[1D:Dialog_MaterialDatabase | material database]]. Alternatively, a predefined assembly may be read from the [[1D:Dialog_ConstructionDatabase | construction database]]. 
  
* You may specify [[1D:Dialog_HygrothermalSources | heat, moisture or air change sources]] within the component. 
  
* You may select [[1D:Dialog_Assembly | monitoring positions]], for which you want to be given the [[Glossary:Glossary-1D | courses]] of temperature and relative humidity (the two surfaces of the building component are always monitored). 
  
* You must specify the [[1D:Dialog_Orientation | orientation, the inclination and the height]] of the building component. 
  
* You must select the [[1D:Dialog_SurfaceTransferCoefficients | surface transfer coefficients]] for heat, vapor and liquid transport. 
  
* You must specify the [[1D:Dialog_InitialConditions | initial conditions]], which describe the starting values of the temperature and moisture fields. 
  
* You must specify the [[1D:Dialog_Time | time interval]] for which the calculation shall be carried out. You may specify additional points in time for which you want to be given [[Glossary:Glossary-1D | profiles]]. 
  
* You may edit the parameters for the [[1D:Dialog_Numerics | numerical control]]. 
  
* You must define the [[1D:Dialog_Climate | climatic conditions]] on each side of the component by selecting a file with weather data or by having interior climate data derived from such a file, or by specifying schematic sine curves for the climate data. 
  
* You may check your input by viewing data sheets of the component assembly, of the material data, or of a table summarizing other input. 
  
* As a precaution, you should now save your input to a [[Glossary:Glossary-1D | project]] file (*.W4P). 
  
* Now you can start the calculation.

1D:SummaryPreparingACalculation - Versionsgeschichte

Len: Die Seite wurde neu angelegt: = Summary: Preparing a Calculation = This is an overview of the steps that have to be taken before you can start a calculation. * You may enter some opt...

Len: Die Seite wurde neu angelegt: = Summary: Preparing a Calculation =
This is an overview of the steps that have to be taken before you can start a calculation.
* You may enter some opt...