Len: Die Seite wurde neu angelegt: = Performing the Calculation =
When you have entered (and saved) all the necessary data, you can start the calculation. To do this,
* choose the menu item ...

2008-08-13T07:04:14Z

Die Seite wurde neu angelegt: = Performing the Calculation = When you have entered (and saved) all the necessary data, you can start the calculation. To do this, * choose the menu item ...

Neue Seite
= Performing the Calculation =


When you have entered (and saved) all the necessary data, you can start the calculation.
To do this,

* choose the menu item "Run | Run Calculation" to start the calculation for the current case, or 

* choose the menu item "Run | Run all Calculations" to start the calculation for all the cases in the current project in succession, or 

* choose the menu item "Run | Run Calculation with Film" to open the [[1D:Dialog_RunCalculationWithFilm | film dialog]] and click on the 'Start' button.


In the former two cases the screen just shows a progress bar so that you can estimate
computing time; in the latter case, WUFI displays the calculated profiles at each time
step, so that you can watch a sort of film showing the processes in the component. This
film display is somewhat slower, of course, so that lengthy calculations should be done
without film; on the other hand, you can immediately see what is happening.


During the calculation, WUFI wanders from the specified initial state through the
evolution of the temperature and moisture fields, proceeding in discrete time steps,
reading the changing boundary conditions from the climate file and writing the data of
each step to a temporary result file. A progress bar allows you to estimate the
remaining time needed for the calculation.


The calculation can be aborted at any time by a click on the stop button. The
results accumulated so far are not lost and can be analysed.


If you have run the calculation with film, you can "Close" the film screen
after the calculation has ended. 
  



After the calculation, a window
[[1D:Dialog_InfoLastCalculationRun | "Status of Last Calculation"]]
pops up, showing you a short summary of the calculation results. This window also
contains some [[1D:Dialog_InfoLastCalculationRun | information]] that you should
check to make sure that no serious convergence failure has occurred.


Important: If you want to keep the results, you must now write them to the
project file by simply saving the project file again (make sure the
[[1D:Dialog_OptionsResultData | options]] are set to save both input data and
results in the project file).


Extensive calculations (such as parametric studies) can also be processed automatically
as [[1D:Batch | batch jobs]].

1D:PerformingTheCalculation - Versionsgeschichte

Len: Die Seite wurde neu angelegt: = Performing the Calculation = When you have entered (and saved) all the necessary data, you can start the calculation. To do this, * choose the menu item ...

Len: Die Seite wurde neu angelegt: = Performing the Calculation =
When you have entered (and saved) all the necessary data, you can start the calculation. To do this,
* choose the menu item ...