Len: Die Seite wurde neu angelegt: = Dialog: ASCII Export = Bild:DialogASCIIExport_02.gif
Instead of viewing the results as graphics, you may also write them to an A...

2008-09-29T08:33:27Z

Die Seite wurde neu angelegt: = Dialog: ASCII Export = Bild:DialogASCIIExport_02.gif Instead of viewing the results as graphics, you may also write them to an A...

Neue Seite

= Dialog: ASCII Export =

[[Bild:DialogASCIIExport_02.gif]]

Instead of viewing the results as [[1D:Dialog_ResultGraphs | graphics]], you
may also write them to an ASCII file and analyse them on your own.



"Courses": 
"Profiles": 
Select from these lists the
[[Glossary:Glossary-1D | courses]] and
[[Glossary:Glossary-1D | profiles]] you want to have output.


Select a single curve with a mouse click. 
If you want to select a contiguous range, first select the curve at one end and
then - with the shift key pressed - the curve at the other end of the range. 
If you want to select several non-contiguous curves, select these one after the
other with the control key pressed.


To deselect a curve, click on it with the control key pressed. 
  



"Output file": 
Enter the (path and) name of the target files for courses and profiles, respectively,
in these text boxes. If you want to use an existing file name or need to search for
a directory, you may also press the button to open a "Save As" dialog. 
  



"Output": 
This button starts the export of the selected data to the specified ASCII file(s). 
  



WUFI writes an ASCII file with several columns. The first column contains an hour
count (courses) or X-coordinates in meters (profiles), the other columns contain
the selected calculation results in the sequence of the selected list. The available
curves are further described in the list of the
[[1D:Dialog_InsertCurves | curves available for the result graphs]].


The results are output in the form in which they have been computed. They are not
affected by the [[1D:Dialog_ResultGraphs | graphics settings]]
(averaging, display of only part of the results etc).


The temperature and/or water content profiles of the
[[1D:Dialog_Time | last]] (or any other) calculation step may be used as
[[1D:Dialog_InitialConditions | initial temperature]] and/or
[[1D:Dialog_InitialConditions | water content]] profiles for the next
calculation. In this way, an extended calculation may be broken up into smaller,
easier manageable parts, or material parameters may be edited between successive
runs in order to simulate aging etc.

1D:Dialog ASCIIExport - Versionsgeschichte

Len: Die Seite wurde neu angelegt: = Dialog: ASCII Export = Bild:DialogASCIIExport_02.gif Instead of viewing the results as graphics, you may also write them to an A...

Len: Die Seite wurde neu angelegt: = Dialog: ASCII Export = Bild:DialogASCIIExport_02.gif
Instead of viewing the results as graphics, you may also write them to an A...